Woodward SECM70 Pin Small Engine Control Module Applications

Outputs:

8 electronic spark triggers for smart ignition coils

9 low-side drivers, 3 lamp drivers

1 main power relay driver to power engine electrical components

2 H-bridge drivers for electric throttle and actuator

1 sensor power (5 V) output

Communication:

2 CAN 2.0b channels

Our online pricing is available for orders up to 50 pieces.

If you require higher volumes, please contact Woodward for volume pricing and/or to purchase modules only (without mounting kit)

Applications 

The SECM70 control platform is suitable for a variety of applications including gasoline and

natural gas engines for power generation, forklifts, forklifts, and on-highway vehicles.

The SECM70 control system is programmed to meet the specific needs of prime movers and the loads they drive.

At the heart of the SECM70 control system is a powerful 32-bit ST SPC563M64 microprocessor running Woodward's ControlCore operating system.

Application programming is done through Woodward's MotoHawk application software tool.

MotoHawk is a rapid control system development tool that allows control engineers to quickly create

control software directly in Simulink diagrams and run it on any MotoHawk enabled electronic control module.

Working directly in the Simulink environment, application developers can turn application models into files

that can be programmed directly into Woodward production hardware in a single build step.

MotoHawk provides an advanced programming environment for users with control system expertise

but not necessarily specific embedded programming skills.

Once the application is generated and loaded into the SECM70 controller via the CAN port,

users can view variables and adjust controls using appropriate service interface tools such as Woodward's ToolKit or MotoTune.

Connectivity to other devices, such as diagnostic tools, can be accomplished through additional CAN ports on the controller.

The required information flow can be programmed into the controller via MotoTune or ToolKit.

The SECM70 controller consists of a rigid printed circuit board that is attached to an aluminum housing with thermal adhesive.

It is then closed and sealed with an aluminum cover. Connection to the controller is made through

a single 70-pin automotive style sealed connector.

The controller can be mounted directly to the engine or frame using vibration isolators pre-installed on the controller or supplied separately.