Prosoft PLX31-MBTCP-SIE Industrial Ethernet Communication Gateway

ProSoft Technology's Modbus® TCP/IP to Siemens Industrial Ethernet Gateway allows for

high-speed bi-directional data transfer between Modbus® TCP/IP controllers and Siemens® S7-400. S7-300. S7-200. S7-1200 and S7-1500 PACs.

In addition, the gateway has a number of features, including data prioritisation, that simplify integration, reduce commissioning time and optimise performance.

Functions

 The ProSoft Discovery Service utility allows your PC to view the gateway and edit its default IP address without being on the same subnet.

 Supports up to 20 simultaneous client and server connections to speed communications between devices such as HMIs, SCADA systems, power monitors, and traffic computers.

 In addition to S7 controllers, the Gateway can also be used with Siemens® S5 controllers with corresponding interfaces.

 The Gateway includes an SD card slot (SD card optional) for storing configuration files. It can be used for disaster recovery.

 Safe module configuration via Module Switch (v1.04 and higher).

 can exchange large amounts of data using up to 10.000 16-bit registers.

Specification Description

Power Supply 24 VDC nominal

10 to 36 VDC allowed

Positive, negative, ground terminals

Current Load 24 VDC nominal @ 300 mA

10 to 36 VDC maximum @ 610 mA

Operating Temperature -25°C to 70°C (-13°F to 158°F)

Storage Temperature -40°C to 80°C (-40°F to 176°F)

Shock IEC 60068-2-27; 15G @ 11ms, 3 axes (in operation)

IEC 60068-2-27; 30G @ 18ms, 3 axes (non-operating)

Vibration IEC 60068-2-6; 5G @ 10 to 150 Hz

Relative humidity 5% to 95% RH, non-condensing

Dimensions (H x W x D) 5.38 x 1.99 x 4.38 in.

13.67 x 5.05 x 11.13 cm

LEDs Configuration (CFG), Error (ERR), Power (PWR), Hardware Failure (FLT), Network Connection (FLT).

Error (ERR), Power (PWR), Hardware Failure (FLT), Network Status (NS), EtherNet/IP™ Class I or Class

Module Status (MS),

Module Configuration Status (EtherNet/IP only) Ethernet

Communication Port Link/Active and 100 mbit

Ethernet ports 10/100 Mbit full-duplex and half-duplex RJ45 connector Galvanic isolation

Isolation 1500 Vrms, 50 to 60 Hz for 60 seconds, applied according to section 5.3.2.

Applied in accordance with IEC 60950 Section 5.3.2: 1991 Ethernet Broadcasts

Storm recovery capability of less than or equal to 5000 [ARP] frames per second for less than or equal to 5 minutes.

2.5 mm screwdriver J180 power connector included with each unit