ABB PGC5000B Smart Oven PGC5000 Series gas chromatographs

PGC5000B Oven:

— Simpler analytical methods

— Creates simple applications with a fixed set of features

— Using multiple ovens creates maximum

application flexibility

— Optimized for maximum analytical capability with

minimal hardware

— All hardware component access points are from the front

of the analyzer

— Flexible platform for product expansion and future

enhancements

— Multiple oven capability

— EPC standard

— Distributed analyzer architecture

— Oven isolation for maintenance and upgrades

— Different oven sizes for application designs

— Analyzer densification for reduction in shelter size

— Industry standard CANopen protocol

— Unlimited application configurations

— Local diagnostic capability

— Controlled and phased analyzer upgrades

— Factory engineered reapplications

— Simple application expansion

Application

Usage

The PGC5000B Smart OvenTM targets simple applications or complex applications that can be made simple. Smart OvenTM

technology can be single or multiple ovens allowing application design flexibility, producing simpler analyses which are easier to

maintain with higher reliability. PGC5000B Smart OvenTM smaller footprint minimizes space and utility requirements, while

increasing analyzer density in shelters.

Description

PGC5000B Smart OvenTM technology supports applications that require a single detector with up to three analytical valves.

Advanced pressure, temperature and stream control software executes analytical methods required for analyses. A single

PGC5000A Controller can support up to four PGC5000B Smart OvensTM reducing space and utility requirements while

increasing applications flexibility

Physical

B-class oven:

Environmental (enclosure): Protected from weather: IP 54, (NEMA 3 Equivalent)

Ambient temperature range: 0 to +50° C (32 to 122° F)

Humidity: 95% relative humidity, non-condensing

Dimensions: 596.9 mm W x 419.1 mm D x 609.6 mm H

(23.5 in. W x 16.5 in. D x 24 in. H)

Weight: 60 kg (132 lb) (minimum, configuration dependent)

Mounting: Wall: 33 mm (1.3 in.) from wall with brackets

Floor: Optional dolly with casters

EMI/RFI considerations: Conform to class A industrial environment

Electrical entries: Left side

Pneumatic entries: Right side

Sample entries: Gas & Liquid: Right side

Vents: Right side

Safety area classification

CSA / NRTL: Class I, Division 1; gas groups B, C, D with type Y-purge

Class I, Division 2; gas groups B, C, D

temperature code T4 – T2

ATEX / IEC / CN / KO: Zone 1: CE 0344; II2G, Ex de py IIB+H2 T4 – T2

Zone 2: CE; II3G Ex de nA nL IIB+H2 T4 – T2

Ex de px IIB+H2 T4 – T2 (optional)

With X-purge power interlock

Purge wait time: 18 minutes (Class I, Division 1 / Zone 1 area)

Power (hot, neutral, ground)

Voltage: 100 – 240 VAC

Frequency: 50-60 Hz

Power consumption: 1,200 Watts startup, 900 Watts steady-state operation

Typical, varies with installed options.

Instrument air

Supply connection: 3/8 inch tube, minimum

Supply pressure: 551.6 kPa (80 psig)

Quality: Instrument grade: Clean, oil free and -34° C, (-30° F) dewpoint

Flow rates: Steady state purge: 127-147 L/min (4.5-5.2 ft3/min) at 20° C, Y-purge types

Analytical detectors

Standard detectors: Single and multiport thermal conductivity, flame ionization, flame photometric

Third party detectors: Consult factory for availability