MITSUBISHI ELECTRIC MELSEC iQ-R Series

cause slower process responses and

cause missed products.

❹ Ultrahigh-speed control of product code printing

The digital output module supports high-speed control and enables an output signal

response time of 2 µs, where dedicated equipment would usually be required. This is

useful when data received from a computer requires printing onto a workpiece, such

as printing product identification information (e.g., date codes, batch numbers) on

packaging after quality testing on a continuous high-speed packaging line.

High-speed Digital I/O Modules

•Available in positive or negative common (for 16-point input), both positive and

negative common (for 32-point input), and with sink or source transistor (for output)

depending on the type of device or sensor wiring

•8-point common terminal (16-point input) enables mixing of different sensor types

on one input module (different response time can be set for each input point)

•Wide-range rated load voltage from 5 V DC to 24 V DC

•18-point screw terminal available for the input, and high-density 40-pin connector

for the output 

High-speed Analog I/O Modules

•High-speed conversion (input:1 μs, output:1 μs) and 16-bit high resolution

•18-point screw terminal block

High-speed analog input

•Synchronization of multiple channels

(inter-modular synchronization increases the number of channels that can be

converted simultaneously)

•Continuous logging enables high-speed collection of contiguous data

(1 μs per channel, 5 μs over four channels)

•Various embedded filters (primary delay, low, high, band-pass filters)

High-speed analog output

•High-speed conversion of 1 μs enables faster response of feedback control

•Faster and smoother predefined wave signal output without requiring additional

programming