Nidec KBDA Digital AC Drive with CSP™*

Rugged Die-Cast Aluminum NEMA 4X / IP65 Enclosure with Hinged Cover

Washdown and Watertight for Indoor and Outdoor Use

Primary Features

Horsepower 1/8 to 5 HP, Programmable

115/230/460 VAC-1ph & 3ph Input

Output 230/460 VAC-3ph for AC Induction Motors

Starting Torque 200%

Digital Display with LED Status Indicators

FDA Approved Finish**

GFCI Compatible

Allows equipment to operate

with Ground Fault Circuit Interruption

circuit breakers or outlets.

Benefits

Saves Time

Easy to Install and Simple to Operate.

Does not require commissioning.

With CSP™ you are up and running

in less than 10 minutes.

Motors Last Longer

Proprietary CL Software

Provides overload protection, prevents motor burnout

and eliminates nuisance tripping. UL approved as

electronic overload protector for motors.

Energy Saving

Uses only the power the application requires.

Replacing constant speed with variable speed

will significantly reduce energy costs.

Customization for OEM’s

When an off the shelf drive does not meet your needs,

KB will work with you to provide a custom drive solution, Ready to Use, “Out-of-the-Box.”

Customization includes: Pre-calibrating or programming of a stock control, adding a custom label or branding,

custom software, PLC functions or designing a new control.

Additional Features

Sensorless Flux Vector Control

Flux Vector Compensation with Static Auto-Tune provides excellent speed regulation

with high torque loads throughout the entire speed range. Auto energy saving at light

loads. Smooth motor torque.

Electronic Inrush Current Limit (EICL™) Protection

Eliminates harmful inrush AC line current during power up.

Multi-Function Output Relay

Can be used to turn equipment on or off, to signal a warning if the drive is put into

“Stop” mode, or to signal if a fault has occurred.

Jog-Local/Remote

Set the drive to Jog Mode or changes between Local (Keypad) or Remote Operation.

Built-in Potentiometer

Quickest way to change motor speed.

Ride-Through

Provides smooth recovery to the previous set speed during a momentary power loss.

Holding Torque at Zero Speed

Resists motor shaft rotation when the drive is in “Stop” mode.

Regeneration Protection

Eliminates tripping due to high bus voltage caused by rapid deceleration of high

inertial loads.

Undervoltage and Overvoltage Protection

Shuts down the drive if the AC line input voltage goes above or below

the operating range.

Short Circuit Protection

Shuts down the drive if a short circuit occurs at the motor (phase-to-phase).

Drive Options

IODA Input/Output Multi-Function Board

Adds up to 17 points of additional I/O.

Modbus Serial Communication Module

See instruction manual for complete description.

Drive-Link™ Programming Kit

Allows PC programming.

On/Off AC Line Switch

Disconnects the AC line.

Class “A” (CE) RFI Filter

Installs inside the drive.

Liquidtight Fittings

Provides a liquid-tight seal for wiring the drive. Kit includes necessary

liquidtight fittings