Eaton JOCKEY Touch™ Microprocessor Based Jockey Pump Controller

INTRODUCTION

1.1 Safety

This technical document is intended to cover most aspects

associated with the installation, application, operation, and

maintenance of the JOCKEY Touch™ Jockey Pump Controllers.

It is provided as a guide for authorized and qualified personnel

only in the selection and application of the JOCKEY Touch™

Controllers. If further information is required by the purchaser

regarding particular installation, application, or maintenance

activity, please contact an authorized EATON representative or

the installing contractor.

1.2 Warranty

No warranties, expressed or implied, including warranties of

fitness for a particular purpose of merchantability, or warranties

arising from course of dealing or usage of trade, are made

regarding the information, recommendations and descriptions

contained herein. In no event will EATON be responsible to the

purchaser or user in contract, in tort (including negligence),

strict liability or otherwise for any special, indirect, incidental

or consequential damage or loss whatsoever, including but not

limited to damage or loss of use of equipment, plant or power

system, cost of capital, loss of power, additional expenses

in the use of existing power facilities, or claims against the

purchaser of user by its customers resulting from the use

of the information and descriptions contained herein.

1.3 Safety Precautions

All safety codes, safety standards, and/or regulations must be

strictly observed in the installation, operation, and maintenance

of this device. Starting types of the JOCKEY Touch™ Jockey

Pump Controller include the following: XTJP-Across the Line,

XTJP-Wye-Delta (Star-Delta).

INSTALLATION AND ELECTRICAL

CONNECTIONS

2.1 Installation and Mounting of the Controller

Carefully unpack the controller and inspect thoroughly. It is

recommended that the controller is located as close as is

practical to the motor it controls.

The controller is not free standing and must be bolted securely

to a wall. For dimensional and weight data please refer to the

respective data sheets for the Jockey Pump Controller.

2.2 System Pressure Connection

The Jockey Pump Controller is equipped with a Pressure

Transducer. The controller is provided with a ¼" NPT female

system pressure connection located on the bottom, external

side of the enclosure.

NOTE: Water lines to the pressure transducer must be free from

dirt and contamination. The pressure should not exceed what

the pressure transducer is rated for.

2.3 Electrical Connections

All electrical connections should meet national and local

electrical codes and standards.

The controller should be located or so protected that they will

not be damaged by water escaping from pumps or pump

connections.

Prior to starting, verify the AC line voltage on the nameplate

matches the supply voltage onsite. Also verify the motor FLA

matches the information on the nameplate.

Inspect all electrical connections, components and wiring for

any visible damage and correct as necessary. Ensure that all

electrical connections are tightened before energization.

Install necessary conduit using proper methods and tools.

Incoming AC line voltage is clearly marked L1. L2. L3 and

ground, located at the top of the motor circuit protector.