Installation
Installation should not be attempted without refer
ring to the applicable Programmable Controller
Installation Manual (See reference 4).
Make sure rack power is off.
Plug the 64 pin connector into the connector on
the base board, and engage snaps.
Place module in rack.
Turn power on.
CPU Installation:
Clear memory using either MS-DOS or
Windows programming software following
instructions in the Programming Software User's
Manual (See reference 1).
PCM Installation:
For the PCM follow the instructions in the Pro
grammable Coprocessor Module Support Software
User's Manual (See reference 3).
Batteries
The Lithium battery (IC697ACC701) is installed as
shown in figure 1. This battery maintains user
memory when power is removed and operates the
calendar clock on the PLC CPU. Be sure to install the
new battery before removing the old battery. Specific
indication of a low battery state is detailed in References 3 and 4.
wechat/whatsapp:
+86-181-4410-0983
Email: kongjiangauto@163.com
Copyright © 2009 - 2024 Cld , All Rights Reserved K-JIANG All rights reserved