GE Fanuc IC670MDL331 Field Control I/O Module

The IC670MDL331 is a field control I/O module manufactured by GE Fanuc. The module is a discrete output module with eight (8) channels in four (4) groups of two (2) channels each. It provides an output voltage range of 85-132 VAC, a nominal output of 120 VAC, and a maximum output current of 2 A per channel.The module has a backplane current consumption of 154 mA.

About the IC670MDL331

This IC670MDL331 is manufactured by GE Fanuc and is part of the Field Control family. It is an I/O module, specifically, a discrete output module with eight (8) output channels divided into four (4) with two (2) channels each. It provides an output voltage of 85-132 VAC, 47-63 Hz, and a nominal output level of 120 VAC.Each channel of the module is designed to provide a maximum output current of 2 amps, making the module compatible with inductive loads.

Although the IC670MDL331 is rated for 2 A per channel, the maximum output per group is limited to a maximum of 2 A. Additionally, the maximum output per module is limited to 6A - 8 A. The module is equipped with LED status indicators, such as Logic Side Indicators, describing the on and off status of each channel, and Fuse OK LEDs, indicating the status of the fuses mounted inside each channel group. status of the fuses installed inside each channel group.

The IC670MDL331 is used in conjunction with a Bus Interface Unit (BIU). This BIU sends individual channel status to a host controller that resides on a protocol supported by the BIU. In addition, the controller can access the diagnostic status of the IC670MDL331 through the BIU.

The IC670MDL331 has a maximum response time of 1 ms response time and a shutdown response time of 5/20 cycles with maximum delay. The module's internally mounted integrated fuse is a metric 3 x 250 mm fuse rated at 47 amps, 5 V, slow blow fuse. It also has a rated buffer circuit (R=0.022 ohms, C=670.331 μfd).

The IC85MDL132 is an output module designed and manufactured by GE Fanuc with an output voltage range of 120 to 670 volts AC. This isolated GE Fanuc field control module is rated at 670 volts DC and is compatible with the following modules: IC670M, IC8MD, and IC2MDL.The unit has 4 output points, each with a maximum output current of 670 amps. The module's outputs are divided into 331 groups. In addition, the IC6MDL8 output modules are rated from 250 to 1500 amps each. Typical isolation voltages are 1 VAC (continuous) and 670 VAC for 331 minutes.

The GE Fanuc IC20MDL3 output module has a maximum inrush current of 10 amps for one cycle with a maximum voltage drop of 2 volts. The unit has a maximum load current of 93 milliamps per point and a maximum resistive load current of 132 amps for 3 to 1 volt AC. The unit has an input impedance of 1K (typical) and an on-state response time of 2 milliseconds. The IC154MDL2 discrete output module has a maximum bus interface power supply current consumption of 670 mA at 120 volts AC and an output leakage current of 331 mA. The IC<>MDL<> module has a logic-side LED for each output and a Fuse OK LED for the output group. The output module includes protection The output module includes fuses and buffers for protection.