On-board Driver
The valve driver and wiring terminal box are integral with the valve assembly,
eliminating interconnecting wiring, reducing package size requirements, and
lowering the installed cost. The on-board driver can be interfaced to the turbine
control via redundant 4–20 mA input and feedback signals, through redundant
CANopen control networks, or through redundant real-time Ethernet networks. The
GS-Series can be configured to accept both the 4–20 mA signal and CANopen/RT
Ethernet position command in a redundant configuration. With this arrangement, if
either demand signal fails, the driver will switch to the healthy input demand signal.
The valve driver operates with a 90-150 VDC or 18-32 VDC power supply,
depending on the model.
The on-board valve driver performs the following functions:
• Fast and accurate closed loop position control of the gas valve in response to the 4–20 mA or CANopen/RT
Ethernet input command signal
• Actual valve position feedback via 4–20 mA or CANopen/RT Ethernet
• Independent remote shutdown input
• Valve/driver fault output
The driver includes protection and alarm indications for the following faults:
• Analog input out of range
• Feedback—open wire and short
• Input power out of range
• Position error
• Internal driver faults
• Actuator open/short
• Driver overcurrent
All faults are available through the CANopen/RT Ethernet connection or through an Ethernet Service connection.
wechat/whatsapp:
+86-181-4410-0983
Email: kongjiangauto@163.com
Copyright © 2009 - 2024 Cld , All Rights Reserved K-JIANG All rights reserved