GE Fanuc General Electric Components IC670GBI001 Bus Interface

The GE Fanuc IC670GBI001 bus interface is for the Field Control Series IC670. IC670G, IC670GB, IC670GBI, and IC670GBI00 modules.

The unit has a nominal voltage rating of 115 volts AC and 125 volts DC.

About the IC670GBI001

The IC670GBI001 bus interface is a GE Fanuc component for field control devices.

GE Fanuc is a well-known producer of technology solutions for many industries, and the GE IC670GBI001 Bus Interface module is resistant to noise in industrial environments,

vibration, high and low temperatures, humidity, and other common conditions in industrial environments.The IC670GBI001 bus interface unit has a nominal voltage rating of 115 volts AC and 125 volts DC.

The input frequency range is 47 to 63 Hz. The unit's voltage range is 90 to 135 volts AC and 105 to 150 volts DC.

The IC670GBI001 Bus Interface Module has a rated power consumption rating of 115 volt-amperes (**value) at 48 volts AC at full load.

The power consumption rating at 24 volts AC at full load is 125 watts (**value). The unit has a hold-up time of 20 milliseconds and a power supply output voltage of 6.5 volts DC.

The IC670GBI002 Bus Interface Module works well with other components such as the Bus Interface Unit power supply and Bus Interface Unit terminal blocks.

The IC670GBI001 module has a high-quality housing made of aluminum and includes LED indicators for status updates as well as an HHM connector for handheld displays.

The IC670GBI001 bus interface unit has a logic power supply and its configuration file is stored in the memory of the terminal block.

The four included indicators are the "PWR", "OK", "Run" and "Bus B" LEDs. The LEDs indicate the normal operation of the module and the communication status with the CPU.

Since the IC670GBI002 unit can be used with a DC power supply, the backplane current may be limited by the lower input voltage.

Technical Information

The GE Fanuc IC670GBI001 interface is a Genius bus interface and is part of the GE Field Control product family.

The interface module is small, rugged, intelligent, and has a stable aluminum housing.

The device also features 4 LEDs and a connector for Genius handheld monitors.

The IC670GBI001 Genius Bus Interface Unit is equipped with a logic power supply, which is necessary for the module to run the attached input/output modules.

It is mounted on a terminal block to which all bus wiring (including the Genius Bus Interface wiring) is connected.

The unit comes with a non-volatile memory located inside the terminal block to help store the configuration.

The input power cord for the Genius Bus Interface utilizes a replaceable slow blow fuse rated at 1 amp at 250 volts AC.

This fuse is removable and replaceable, eliminating the need to disassemble the wiring of any module in the unit.

There are 4 LEDs on the GE Fanuc IC670GBI001 Genius bus interface.

These include the "PWR" LED indicator, which illuminates to indicate that the 5-volt power level required for logic operations is present in the interface.

There is also the "OK" LED which, when lit, indicates that the module has successfully passed the power-up diagnostic test.

Other LED indicators include the "BUS B" LED (illuminated when the Genius BUI is installed on a redundant or dual bus) and the "RUN" LED

(illuminates only when the output module is in proper configuration on the IC670GBI001 Genius bus interface and is wired through the controller of the bus controller).