GE Fanuc IC670CHS003 I/O Terminal Block

Product Description

The GE Fanuc IC670CHS003 I/O Terminal Block with wire-to-board connectors is an assembly that

used to terminate application wiring into a 20-pin male connector for easy connection and disconnection of modules.

It is compatible with hot-swap operation and can accommodate up to 20 different wires, with each wire assigned a use pin based on the module selected for a particular application.

GE Fanuc designed and manufactured the IC670CHS003 terminal block in the Field Control family to accommodate user needs and different wiring preferences.

Designed for easy installation and wiring to the board interface, the IC670CHS003 I/O Terminal Block has wire-to-board connectors.

As the name implies, the terminal block is connected to the inputs via wires (typically AWB 16-20 gauge wire).

The terminals are then connected to GE Fanuc connectors for quick insertion or removal of I/O modules.

The GE Fanuc IC670CHS003 I/O terminal block with wire-to-board connectors can accommodate up to 20 individual connections or pins to a male connector assembly.

The female connector that mates with the IC670CHS003 I/O Terminal Board's male connector is part number 178289-8.

Each pin of the terminal block will have a different function depending on the end user application.

The user manual for the GE Fanuc IC670CHS003 I/O Terminal Block will guide the user in connecting the different GE Fanuc modules to the terminal block.

It is the user's responsibility to provide the installer with the proper crimping tools to properly complete the cable connections in the terminal board.

Only trained personnel with extensive electrical experience should make connections to the GE Fanuc IC670CHS003 I/O terminal board,

disconnect, troubleshoot, and perform maintenance work. Due to the low environmental protection rating (IP 20) of this terminal block and its wiring, it is strongly recommended that the terminal block be placed inside a protective panel board.