GE Fanuc IC200ALG432 Hybrid Analog Module

The IC200ALG432 module is an analog module with mixed inputs. It is manufactured by GE Fanuc as a Versamax module.

About the IC200ALG432

The GE Fanuc IC200ALG432 module is a hybrid analog module that runs on a 10-volt DC power supply.

It is a 12-bit module equipped with 4 channels and 2 output channels.

The analog module has an update rate time of 0.4 milliseconds and an input response time of 5 milliseconds.

The analog module requires an external power supply to power the outputs. The inputs of the module are powered by the external power supply of the transceiver.

The CPU is present in the module that handles the operation. the IC200ALG432 module has LEDs on the front of the module that indicate the flow of power and backplane currents.

No thermal derating occurs in this hybrid module. the IC200ALG432 module draws a total of 160 milliamps of current during normal operation. including load current.

The diagnostic feature of the module helps to detect the loss of power on the user side.

It provides four channels and two channel outputs. The outputs require a 24V external power supply and the inputs are powered from the transceiver's external power supply.

The CPU or NIU performs intelligent processing of the IC200ALG432 module. Includes 4 words of analog input data and 2 words of analog output data.

This IC200ALG432 uses LEDs to indicate the presence of user-side power for analog field-side circuits as well as backplane power.

The LEDs emit a green light when operating as intended. When properly installed, this module reports the loss of user-side power failure for field-side circuits and conveniently sets up jumpers for outputs.

The IC200ALG432 can be set to maintain the last state or default values even if the backplane or field power is temporarily interrupted. The module reports the loss of user-side power failures for field-side circuits.

The recommended range for the module's external power supply is +18 to +30 VDC. this includes power consumption ranging from 160 mA ripple.

The +/- 10 VDC input range should be noted. It is recommended that shielded cables be installed with the source device or I/O module grounded.

The GE Fanuc IC200ALG432 module comes with configurable alarms that can be set for different events.

During installation, the module should be protected from traces of electromagnetic noise and airborne contaminants.

The temperature of the installation area should not exceed 60 degrees Celsius. The accuracy of the module depends on the ambient temperature.

At 25 degrees Celsius it has +/-0.3% of full scale accuracy and at 60 degrees Celsius it has +/-1%** accuracy.

The IC200ALG432 module has an 8 count resolution. The module has a common mode voltage of 0 volts.

The IC200ALG432 module draws 5 milliamps of current from a bus running from a 60 V supply.