GE Fanuc IC200ALG431 Analogue Hybrid Module

About IC200ALG431

The IC200ALG431 module is a hybrid module from Agfaq. It is a 12-bit device for industrial automation applications.

The analogue module provides flexibility by combining inputs and outputs using a single carrier base.

The front of the module has LED indicators that help the operator understand the flow of power in the module.

The module has "FLD PWR" and "OK" LED indicators. The module is compact in size with a width of 4.30 inches, a depth of 1.95 inches and a height of 2.63 inches.

The IC200ALG431 module weighs approximately 4.4 lbs. The module is equipped with a 0 to 10 volt DC analogue input and a 0 to 10 volt DC analogue output. The module is powered by an external power supply.

The IC200ALG431 module uses shielded twisted pair cable for analogue channel connections.

During module installation, the module should be properly grounded to the source device.

If the module is connected through a carrier using a connector type, it can be connected to the plug-in terminals.

Hybrid modules are equipped with diagnostics that help report circuit faults. The I/O defaults in the module can be used with jumpers.

The IC200ALG431 module draws a total of 60 mA from the 5 volt bus interface unit.

The module can be easily installed into a system by using panel mounting.

This is an indoor unit designed with an open architecture. It should be protected from water spray and kept away from heat sources.

The ambient temperature should not exceed 60 degrees Celsius.

Technical description of IC200ALG431

The IC200ALG431 module is an Agfanac module in the Versamax series. It is a 12-bit module.