Signalling an Unsafe Condition
A no flame condition occurs when the FAU810 logic determines that an unsafe condition exists.
Remote Monitoring
Extended setup, parameter archiving, group viewing, advanced diagnostics including flame raw data,
real-time and historical trending for up to 254 networked scanning heads.
Networking with the DTM is possible via the PC-based software package
Flame ExplorerTM or via any Profi Bus DP-V1 master remote control.
FAU810 Specifications
Each flame analysis unit consists of two independent channels.
Each channel receives and processes one flame detector signal.
The two detectors can be any combination of the following designs:
- SF810 Flame Scanning Head
- All DFS flame scanning heads
- Flame Rod (Ion Flame Monitoring)
Each detector can be independently configured via the FAU810 pushbutton and display,
the Flame Explorer engineering tool or Profibus.
The FAU810 can be powered by a single or redundant 24 VDC power supply (+/- 20%).
The FAU810 has a built-in diode auction for power isolation.
Two digital input channels are available for remote parameter switching.
One digital input per sensor.
(Example: Dedicated flame detector parameters can be customised to monitor coal or oil burning)
The FAU810 can be upgraded in the field based on official releases of
new product features through a proprietary firmware download tool.
wechat/whatsapp:
+86-181-4410-0983
Email: kongjiangauto@163.com
Copyright © 2009 - 2024 Cld , All Rights Reserved K-JIANG All rights reserved