Emerson AMS 6500 Protection Monitor Configuration

Pre-configured user-selectable measurement types simplify software configuration

Password protection with 4 user login levels and customisable access rights

Context-sensitive help information to quickly resolve set-up issues

Includes trending, time functions, order analyses and start/stop data for comprehensive setup.

Configuration includes setup of basic predictive functions, including troubleshooting and diagnostics

Applications

The AMS 6500 Configuration Software for Machinery Protection allows you to configure protection modules, view real-time vibration monitoring systems and sensor health.

The intuitive configuration process begins with the selection of the card type. Next, the configuration software displays a simple table view.

All configuration settings are clearly visible. Tabs help you categorise information between inputs, outputs, advanced machine diagnostics and management tasks.

diagnostic and management tasks. The allowable range for each required entry is clearly visible to help you understand the range of the parameter.

Preset parameters are automatically loaded when using Emerson sensors and transducers.

Real-time data can be displayed during system configuration to verify that wiring, card settings, and instrumentation are healthy and properly connected.

Real-time information such as gap voltage, waveform data, and overall vibration data can be viewed.

Ongoing maintenance functions such as resetting latching relays or loading saved configurations can be easily performed via software.

The software can be run on a PC or laptop.

The System Configuration Software allows you to configure the following monitors of the A6000 series

The following monitors of the A6000 series can be configured:

a6110. a6120. a6125. a6140. a6150. a6151. a6210. a6220. a6310. a6312. a6312-8.

a6410. a6620. a6630. a6740.a6740-10. a6824. a6824r

Basic Predictive Features

The AMS 6500 Configuration Software has a number of built-in trending functions that allow basic troubleshooting and prediction of the machine.

Master value trends are graphically represented, showing both card health and alarm values. The software can display vibration signals as a function of time,

The software displays the vibration signal as a function of time, the date of the FFT analysis with a resolution of up to 400 lines, and the FFT phase data. The software also displays the last time the machine was started or stopped.

The configuration software visualises the data and displays velocity over time and vibration over velocity for each channel.

Configuration Software

The configuration suite contains the following sections:

CD-ROM containing the configuration of the AMS 6500 protection module

Installation instructions

2 metre configuration cable with 9-pole SUB D plug and 6-pole miniature DIN diode plug for connection to AMS 6500 Protection Monitor

9-pole SUB D DV adapter on 25-pole SUB D, type AB914F

Two adapter cables with SMB coaxial plugs on both sides for connection of oscilloscopes to the AMS 6500 Protection Monitor.

Length 3 metres, supplied by Radiall, type 296-201-794

Two adapters BNC/SMB R191 209. supplied by Radiall

USB to RS232 adapter

Configuration programme

The configuration software package contains the following programmes:

A6910 Configuration Software for AMS 6500 Protection Monitor

System requirements

To load the programme, the PC or laptop must fulfil the following minimum prerequisites:

Standard PC/laptop, Pentium II or higher, minimum clock frequency 500 MHz, CD-ROM.

RS232 interface port (or USB (when used with an external USB to RS232 converter)).

Operating System Windows 2000. Windows XP, Windows Vista or Windows 7