Honeywell EP-DOCX-SCA-SMSC-100 Universal Marshalling Solution Functions 2

• Digital Output Relay Adapter - FC-UDOR01 is a SIL 3 Normally Open single channel relay output module for low

voltage applications. Contact side of the relay interfaces with the field device and the coil side gets connected to

safety system. This module does not require external power to operate.

• Digital Output Relay Adapter F&G - FC-UDOF01 is a SIL 3 Normally Open single channel relay output module for

low voltage applications. The adaptor is capable to drive high current field devices. Contact side of the relay

interfaces with the field device and the coil side gets connected to safety system. This module does not require

external power to operate.

• Analog Input Adapter, type 3 wire - FC-UAIA01 is a single channel analog input module which supports three wire

sensors. Only if used in 3-wire mode, this module requires an external power to operate. This gets connected to the

UIO module of the safety system.

• Analog Input Adapter, type Sink - FC-UAIS01 is a single channel analog input module which supports source type

sensors. This module does require an external power to operate. This gets connected to the UIO module of the

safety system.

• Digital Namur proximity switch Adapter - FC-UDIN01 is a single channel digital input module for digital proximity

switches. Output side interfaces with the field device and the input side gets connected to the UIO module of the

safety system. This module does not require external power to operate.

• Digital Namur safety proximity switch Adapter - FC-UDNS01 is a single channel digital input module for digital

safety proximity switches.  Output side interfaces with the field device and the input side gets connected to the UIO

module of the safety system. This module does not require external power to operate.

• Analog Input Barrier Adapter – FC-UGAI01 is a single channel analog input barrier module, for Intrinsically Safe

Analog Input devices. Output side interfaces with the field device in a non-Safe zone and the input side gets

connected to the USIO module of the safety system. This module does not require external power to operate.