Optimized control of proportional valves with PWM
The EL2535-xxxx output terminals are specially designed for the
precise control of single and double-coil proportional valves and
proportional solenoid valves. They regulate the output current
through pulse width modulation (PWM) of the supply voltage
and are electrically isolated from the E-bus. The current values

(0 to maximum output current) are specified by the automation
device through a 16-bit value. The output stages are protected
against overload and short circuit. Each EtherCAT pulse width
current terminal contains two channels whose signal state is
indicated by LEDs. The light emitting diodes simplify local
diagnosis by displaying typical load and wiring faults.
Special features:
• 2 PWM outputs with push-pull output stage
• suitable for inductive loads > 1 mH
• max. output current ±2 A per channel at 24 V DC nominal voltage
wechat/whatsapp:
+86-181-44100-983
Email: kongjiangauto@163.com
Copyright © 2009 - 2024 Cld , All Rights Reserved K-JIANG All rights reserved