Bently 3500/15 AC and DC Power Supplies

DESCRIPTION

The 3500/15 AC and DC power supplies are half-height modules that must be installed in the designated slots on the left side of the

The 3500/15 AC and DC power supplies are half-height modules that must be installed in the designated slots on the left side of the rack.

Must be installed in the designated slots on the left side of the rack. 3500 Racks can contain one or two AC and DC power supplies.

The 3500 rack can contain one or two AC and DC power supplies. Either power supply

Either power supply can power the entire rack.

When two power supplies are installed in the rack, the power supply in the lower slot serves as the power supply for the entire rack.

power supply in the lower slot serves as the primary power supply, and the other power supply in the upper slot serves as the backup power supply.

serves as the backup power supply. If a second

power supply is the backup power supply for the main power supply.

Removing or inserting either power supply module will not affect the operation of the rack.

As long as the second power supply is installed, the operation of the rack will not be interrupted.

Operation of the rack will not be interrupted as long as a second power supply is installed.

The 3500/15 AC and DC Power Supply accepts a wide range of input voltages and converts them to a wide range of output voltages.

The 3500/15 AC and DC power supplies accept a wide range of input voltages and convert them to voltages acceptable to other 3500 modules.

For use with other 3500 modules. The following power supplies

are available for the 3500 Series Mechanical Protection

systems:

General purpose AC power supplies

High voltage DC power supplies

Low Voltage DC Power Supplies

Compliance and

Certification (Approval Pending)

FCC

This device complies with

Part 15. Operation is subject to

the following two conditions:

This equipment shall not cause harmful

interference.

This equipment must accept any

interference, including

interference that may cause

of interference.

Electromagnetic compatibility

European Community Directive:

EMC Directive 2014/30/EU

Standards:

EN 61000-6-2; Industrial Environmental Immunity

Industrial Environmental Immunity

EN 61000-6-4; Industrial Environmental Emission

Industrial Environmental