Prosoft AN-X4-AB-DHRIO EtherNet/IP™ to Remote I/O or DH+ Gateway Bridge Mode

Remote I/O Scanner

This operating mode allows users to replace their existing Remote I/O PLC with a ControlLogix or

CompactLogix PAC without having to replace existing racks of I/O.

Build new controller programs without interrupting existing controls, minimizing downtime

Supports up to 32 racks of Remote I/O

Supports all Remote I/O baud rates (57.6. 115.2. and 230.4 K baud), and Remote I/O addressing 0 to 76 octal

Auto-Configuration utility discovers baud rate and maps discrete I/O, reducing configuration errors

Remote I/O Adapter

This operating mode allows PLC’s on Remote I/O to share data with a newer ControlLogix or CompactLogix PAC’s.

This mode also allows a ControlLogix processor to monitor Block Transfer and I/O data on an active Remote I/O network without occupying a drop.

Supports up to 16 EtherNet/IP I/O connections to a Logix processor

Supports any combination of Remote I/O rack addressing

Auto-configures rack addressing and baud rate

Bridge Mode

This operating mode allows the module to listen to all messages on an Ethernet network and

use its “BridgeIP” mapping to forward the messages out of the DH+/BH port. 

The messages received on the DH+/BH port can be forwarded to the devices connected to its Ethernet port.

Allows the use of existing Blue Hose cabling for EtherNet/IP communication:

I/O to Controllers

HMI to SCADA

Programming Controllers via PC

Support for up to 64 AN-X4-BRG, each on different Ethernet network

DH+ mode supports up to 230k Baud Rate

Blue Hose mode supports up to 460K Baud Rate