ABB AF1250 Low voltage AF contactors

ABB’ range of AF contactors is the industry benchmark. 

The integrated electronically controlled coil offers

multiple benefits over conventional alternatives, and together  with

ABB’s wide product offering an optimal configuration, every time.

AF1250 3-pole contactors are designed for switching power circuits up to 1260 A (AC-1) or 1210 A UL/CSA

general use. Thanks to the AF technology, the contactors accept a wide control voltage range

(48...500 V 50/60 Hz and 24...500 V DC) with only 4 coils managing large control voltage variations,

reducing panel energy consumptions and ensuring distinct operations in unstable networks.

Furthermore, PLC control and surge protection is built-in, offering a compact solution. AF contactors

have a block type design, which can be easily extended with add-on auxiliary contact blocks and an

additional wide range of accessories.

Product conformity & compliance

REACH (Regulation EC 1907/2006)

AF contactors and related accessories were

classified as Articles and, during normal and

reasonably foreseeable conditions of use, do not

intentionally release any substance or preparation.

ABB continuously undertakes communications

throughout its supply chain in order to collect

information about suppliers’ compliance with

REACH regulation.

SVHC (Regulation EC 1907/2006 REACH)

ABB continuously assesses its products for content

of Substances of Very High Concern (SVHC), as

included in the “Candidate List” by the European

Chemicals Agency (ECHA). According to our best

knowledge, AF contactors and related accessories

do not contain SVHC substances exceeding

0.1 % w/w.

RoHS II

AF contactors and related accessories are within the

scope of Directive 2011/65/EU (RoHS II) and

Amendment 2015/863. starting from July 22 2019.

WEEE

The Waste Electrical and Electronic Equipment

Directive (WEEE Directive) is the European

community directive 2012/19/EU on waste electrical

and electronic equipment (WEEE) which, together

with the RoHS Directive, became European law in

February 2003.

Product safety

Compliance with essential health and safety

requirements has been assured by compliance with

the applicable product and safety standards.

The validation according to the product and safety

standards is carried out by third party tests

laboratory (STIEE / TL030) in respect of the EN ISO/

IEC 17025 European standard, according to IECEE CB

scheme. CB certificate has been issued.