Bently Nevada 3500/93 System Display Asset Condition Monitoring

Description

The 3500/93 System Display is designed to meet the requirements of American

Petroleum Institute (API) Standard 670 and provide local or remote visual

indication of all 3500 Machinery Protection System information residing in the

rack including:

 System Event List

 Alarm Event Lists

 All Channel, Monitor, Relay Module, Keyphasor* Module or Tachometer

Module data

The 3500/93 System Display is configured using 3500 Rack Configuration

Software. The display can be mounted in any of four ways:

1. Face Mounting – display installs directly over the front panel of any full

size 3500 rack using a special hinged support. This permits access to the

rack’s buffered output connectors and user-interface buttons and

switches without disconnecting or disabling the display.

Note: For this mounting option only, the Display Interface Module (DIM)

must be installed in slot 15 (right-most slot) of the rack. The Face

Mounting option is not compatible with the 3500 Mini-rack.

2. 19-inch EIA Rack Mounting – display is mounted on 19-inch EIA rails and

located up to 100 feet away from the 3500 System. (Up to 4000 feet

away from the 3500 System when using the External Power Supply).

3. Panel Mounting – display is mounted in a panel cutout located in the

same cabinet or up to 100 feet away from the 3500 System. (Up to 4000

feet away from the 3500 System when using the External Power Supply).

4. Independent Mounting – display is mounted flush against a wall or

panel and located up to 100 feet away from the 3500 System. (Up to

4000 feet away from the 3500 System when using the External Power Supply). 

Up to two displays can be connected to each 3500 rack and each display

requires one empty 3500 rack slot for insertion of its corresponding DIM. When

the display is not face-mounted, the cable connection between the DIM and the

Display can be made from the front of the 3500 rack or from the I/O module at

the rear of the rack.

Applications that require a cable longer than 100 feet must use the External

Power Supply and Cable Adapter. Applications that use the back lighted Display

Unit must use the External Power Supply. There are two External Power Supplies:

one for connection to 115 Vac and the other for connection to 230 Vac.

The External Power/Terminal Strip Mounting Kit eases installation of External

Power Supplies. The External Power/Terminal Strip Mounting Kit is designed to fit

in the Independent Mount Housing. The Kit streamlines installation of an External

Power Supply in both the Independent Mount Housing or a user supplied housing.