Bently 3500/15 AC and DC Power Supplies

Bently Nevada Machinery Condition Monitoring

Description

The 3500/15 AC and DC Power Supplies are half-height modules and

must be installed in designated slots on the left side of the rack. The

3500 rack can contain one or two power supplies with any combinations

of AC and DC. Either supply can power a full rack.

When two power supplies are installed in a rack, the one in the lower

slot acts as the primary supply, and the other in the upper slot acts as

the backup supply. If installed, the second supply is the backup for the

primary one.

Removing or inserting either power supply module does not disrupt

operation of the rack as long as a second power supply is installed.

The 3500/15 AC and DC Power Supplies accepts a wide range of input

voltages and converts them to voltages acceptable for use by other

3500 modules. The following power supplies are available with the 3500

Series Machinery Protection System:

• Universal AC Power

• High Voltage DC Power Supply

• Low Voltage DC Power Supply

The Universal AC Power Supply and PIM (Power Input Module)

are not compatible with the Legacy 3500 AC Power Supply,

High Voltage AC PIM and Low Voltage AC PIM.

The High Voltage and Low Voltage DC Power Supplies and

PIM(Power Input Module) are NOT compatible with the Legacy

3500 High Voltage and Low Voltage DC Power Supplies and PIMs.

Compliance and Certifications

FCC

This device complies with part 15 of the FCC

Rules. Operation is subject to the following two

conditions:

• This device may not cause harmful interference.

• This device must accept any interference

received, including interference that may cause undesired operation.