Product Overview
PMCspan is a PMC carrier module that provides PCI expansion capability
for an MVME2300/MVME2600/MVME2700/MVME3600/ or
MVME4600 host VME processor module. The PMCspan has two PMC
slots which support either two single-wide PMC adapters or one double
wide PMC adapter. Two PMCspan modules can be stacked on a host VME
processor, allowing up to four additional PMC adapters.

PMCspan Models
There are three PMCspan models:
o PMCspan-001: Primary PMC Carrier Module that attaches to the
MVME2600/2700/3600/4600 and provides two PMC slots. It
includes a DEC 21150 PCI-to-PCI bridge chip with 32-bit PCI
support and accepts a PMCspan-010 Secondary PCI Expansion
Module.
o PMCspan-002: Primary PMC Carrier Module that attaches to the
MVME2300 and provides two PMC slots. It includes a DEC 21150
PCI-to-PCI bridge chip with 32-bit PCI support, and accepts a
PMCspan-010 Secondary PCI Expansion Module.
o PMCspan-010: Secondary PMC Carrier Module that attaches to
either a PMCspan-001 or PMCspan-002 and provides two PMC
slots. The PMCspan-010 is identical to the PMCspan-001/-002
except that the PCI-to-PCI bridge chip, the Clock Configuration
logic, and the primary PCI expansion connector are not present.
All PMCspan models provide both front panel and VME bus I/O.
PMCspan Features
PMCspans have the following features:
o They are operational with the MVME2300/2600/2700/3600/4600
processor modules.
o They provide support for two single-width PMC adapters or one
double-width PMC adapter.
o They incorporate 5V bus signaling voltage.
o They incorporate both PMC Bus and VMEbus connectors with the
following features:– Two sets of three EIA E700 AAAB connectors for
32-bit PMC interface to secondary PCI bus and user specific I/O.
– P1 connector for power and BGNT and IACK daisy chaining.
– 5-row P2 connector for power and PMC I/O.
o They incorporate a DEC 21150 PCI-to-PCI Bridge Interface device,
with the following features (PMCspan-001/-002 only):
– PCI Revision 2.1 compliant.– 32-bit primary bus interface.
– 32-bit secondary bus interface.
– Delayed transactions for all PCI configuration, I/O, and memory
read commands, allowing up to three transactions simultaneously in
each direction
– Buffering (data and address) for posted memory write commands
in each direction, allowing up to five posted write transactions
simultaneously in each direction.
– Read data buffering in each direction.
– Concurrent primary and secondary bus operation to isolate traffic.
– Enhanced address decoding.
– PCI transaction forwarding
ESD Precautions
Motorola strongly recommends that you use an antistatic wrist strap and a
conductive foam pad when installing or upgrading a system. Electronic
components such as disk drives, computer boards, and memory modules
can be damaged by ESD. After removing the component from the system
or its protective wrapper, place the component on a grounded and static
free surface (and in the case of a board, component side up). Do not slide
the component over any surface.
If an ESD station is not available, you can avoid damage resulting from
ESD by wearing an antistatic wrist strap (available locally) that is attached
to an unpainted metal part of the system chassis.
Installing PMC Adapters
PCI mezzanine card (PMC) adapters mount on the PMCspan. Install the
PMC adapter modules on the PMCspan prior to installing the PMCspan
onto the VME processor module. Refer to the installation instructions that
come with the PMC adapter for any prerequisites.
Note The PMCspan is keyed to accept only 5V PMC adapter
modules. 3. Slide the PMC module port connector into the PMC slot opening
on the PMCspan front panel
4. Align the PMC adapter over the PMCspan.
– Align the connectors on the underside of the PMC adapter with the
corresponding connectors (J11. J12. and J14) on the PMCspan.
– Align the keying hole on the PMC adapter with the keying pin on the
PMcspan.
5. Gently press the PMC adapter onto the PMCspan.
6. Turn the PMCspan component-side down.
7. Insert the four short Phillips screws supplied with the PMC adapter
through the holes on the underside of the PMCspan, into the
wechat/whatsapp:
+86-181-44100-983
Email: kongjiangauto@163.com
Copyright © 2009 - 2026 Cld , All Rights Reserved K-JIANG All rights reserved